CYBEX 700T Manual de Serviço descarregar pdf (Página 83)

Cybex 700T Treadmill Owner’s Manual

Page 7-20

To turn off a Service Reminder, press the + key, and the right window will display the Service

Reminder clear command (nnC).

Example 2:

ErrC nnC

Press START to accept the clear command(s) and advance to d1.

Active keys during this test (hold keys for two seconds):

START/ENTER will accept the displayed state of the Error Log and Service Reminder

and advance you to the first diagnostic test.

STOP will accept the displayed state of the Error Log and Service Reminder and will exit

and return you to the mode you were in prior to entering the diagnostic tests.

SHIFT accepts the displayed state of the Error Log and Service Reminder and backs

you up one step in diagnostic test menu.

The v^ keys toggle the Error Log from Set (S) to Clear (C).

The - and + keys toggle the Service Reminder from Set (S) to Clear (C).

d13: Power Relay Test

This test allows you to test (activate) the power relay on the lower electronics PCB. Pressing

the v elevation button in conjunction with the SPEED + button will toggle the relay on/off. You

should be able to hear the relay toggle and note as well that the value in the right window

should read “1.” If the number displayed in the right control panel window is “1,” then the

power relay control wiring is OK. If the value displayed is “0,” then the relay can not be

controlled by the display.

Active keys during this test (hold keys for two seconds):

START/ENTER will advance you to the next diagnostic test.

STOP will exit and return you to the mode you were in before entering the

diagnostic tests.

SHIFT backs you up one step in the diagnostics test menu.

d14: CSAFE Port Check

This test checks the status of the CSAFE port on the back of the console. CSAFE is the

industry standard for connecting to fitness equipment. The port is tested at the factory, but

the status can be checked at any time. The test will indicate one of three states:

CSAF Good Indicated when a test plug is installed (factory test).

CSAF run Indicated when a CSAFE compatible

communication device is present and running.

CSAF OPEn Indicated when the port is open, or not

responding to a CSAFE device.

EXIT...PRESS STOP

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89 90

Sem comentários

CYBEX 700T Manual de Serviço Página 83