CYBEX 700T Manual de Serviço descarregar pdf (Página 51)

C. Place the front end panel in

position on the front of the

treadmill. See Figure 8.

D. Using the Allen wrench, attach

the front end panel with four

button head screws and four

star washers. See Figure 8.

9. Attach the motor cover.

A. Place the motor cover in

position on the base. See

Figure 9.

B. Using a Phillips head

screwdriver, tighten the two

screws to fasten the motor cover

to the base. See Figure 9.

10. Position the pads.

A. One person should lift the front end

of the treadmill, while a second

person places a rubber pad

underneath each elevation gear rack.

11. Connect CSAFE.

NOTE: If necessary, install optional

CSAFE-compatible

communications. If not skip to

the next section, Test the 700T

Operation

A. Plug the CSAFE communications

cable into the RJ-45 (8-pin) female connector located on the back of the console.

! WARNING: Be sure that all electrical requirements are met as indicated in the

specifications at the front of the manual and at the beginning of this

chapter prior to proceeding.

Cybex 700T Treadmill Owner’s Manual

Page 5-8

Screws (4)

Star Washers (4)

Front

Panel

Figure 8

Motor

Cover

Screws

Figure 9

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

Sem comentários

CYBEX 700T Manual de Serviço Página 51