CYBEX 400T Guia do Utilizador descarregar pdf (Página 46)

AutoView 400 Installer/User Guide

Configure your terminal program to the following settings:

38,400 Baud

8 Bits

No Parity

1 Stop Bit

No Flow Control

Activate the OSD menu on your AutoView 400 by tapping the Control key

twice. Enter Control twice more to activate the Administrator Commands

screen and then select Administrator Functions.

Use the down arrow key to highlight the menu selection for FLASH Upgrade,

then hit Enter.

A menu screen will appear and ask if you wish to continue. You must type out

the word ‘Yes’ before proceding. Once you have done this, the AutoView

will go into a standby mode and wait for data from the computer. (Note: The

keyboard, video and mouse are disabled during the FLASH upgrade.)

The final step is to send the FLASH file from your terminal program. To do

this, you will need to use the transfer function of your communications

software. Send the FLASH file using the XMODEM protocol. The transfer

should be completed within four minutes.

The AutoView 400 will automatically check the upgrade and make sure that

it is valid. If the AutoView detects an error it will abort the upgrade and

prompt you to re-transfer the file. Otherwise, it will return the message

“Flash Upgrade Successful”.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Sem comentários

CYBEX 400T Guia do Utilizador Página 46