CYBEX 400T Guia do Utilizador descarregar pdf (Página 25)

Once you have activated the main OSD Window, you can open the Command

Menu by pressing either of the Control keys twice.

The Command Menu options are selected in the same manner as channels in

the OSD Window. Scroll the Highlight Bar up and down and press Enter

when your selection is highlighted.

THE COMMAND MENU

On-Screen Display Operations

If you are operating in non-secure mode or are the system administrator,

you will have several options that do not appear in the User level Command

Menu: Add Channel, Edit Channel, Delete Channel and Administrator

Functions are all covered in separate sections in this chapter. Scanning is

covered in Chapter 6.

If you experience a loss of mouse signal while using the AutoView 400,

select the ‘Reset PS/2 Standard Mse/Kbd’ option from this menu for a PC

with a standard mouse driver or ‘Reset PS/2 Wheel Mse/Kbd’ if you are

using a PC with a Microsoft IntelliMouse or other wheel mouse driver. This

will reset and in most cases restore your mouse signal. These commands

are equivalent to the <CM>MR<Enter> and <CM>MW<Enter> keyboard

command listed in the ‘System Control & Maintenance’ section of this

manual.

Choose the option ‘Version Information’ to display on your monitor the

current version level of your AutoView 400 firmware. Press the Esc key to

clear this information from your screen.

Reset PS/2 Standard Mse/Kbd

CYBEX Control Panel

Administrator Commands

Add Channel

Delete Channel

Scanning is OFF

Version Information

ENTER = activate ESC = exit

Edit Channel

Administrator Functions

Setup Scan List

Reset PS/2 Wheel Mse/Kbd

The Command

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Sem comentários

CYBEX 400T Guia do Utilizador Página 25